Solar Charging Controller

Solar Charging Controller

Mppt 12V 24V Auto With LCD Intelligent Solar Panel Battery Regulator . Full digital technology, high charge conversion efficiency up to 99.5% · Full automatic electronic protect function · Charging target voltage and charging recovery voltage can be set Product description Overview: Smart-MPPT...

Send InquiryChat Now

Mppt 12V 24V Auto With LCD Intelligent Solar Panel Battery Regulator . Full digital technology, high charge conversion efficiency up to 99.5%

· Full automatic electronic protect function

· Charging target voltage and charging recovery voltage can be set


Product description

Overview:
Smart-MPPT series intelligent MPPT solar controller is programmable and especially for solar light system. The charging efficiency is 3% higher than Non-MPPT, which can make the cost of the whole system much lower.

Features:
  1.Innovative Max Power Point Tracking(MPPT) technology, tracking  efficiency >99.5%
  2. Full digital technology, high charge conversion efficiency up to 96%
  3. Full automatic electronic protect function

  4.One stop solution design with a key operation, to make it more easy and convenient to use

 5. Built in 12V/24V battery automotive identification function

Technical Data:  

Battery Type

12V

24V

Max. PV input voltage

5V

54V

Max. PV input current

30A

Rated PV charge current

30A

Max discharge current

36A

Rated discharge current

30A

Over charge protection voltage

15±0.3V

30V±0.3V

Over discharge protection voltage

10.5V±0.5V

21V±0.3V

Charge return voltage

13V±0.5V

26V±0.3V

Over discharge return voltage

12.0V±0.3V

24.0V±0.3V

Temperature compensation(mV/)

-3/℃/2V

No load current (mA)

20

Environment temperature

-25℃~+45℃

Altitude(m)

≤5500


CAUTION: Indicates a critical procedure for safe and proper operation of the controller

NOTE:  Indicates a procedure or function that is important to the safe and proper operation of the controller.

General Safety Information

·Read all of the instructions and cautions in the manual before beginning the installation.

·There are no serviceable parts for this controller. Do NOT disassemble or attempt to repair the controller.

·Do NOT allow water to enter the controller.

·Make sure all connections going into and from the controller are tight.

Charge Controller Safety

·NEVER connect the solar panel array to the controller without a battery. Battery must be connected first. Then connect the solar panel(s), connect the load terminal lastly.

·Ensure input voltage does not exceed 100VDC to prevent permanent damage. Use the Open Circuit (Voc) to make sure the voltage does not exceed this value when connecting panels together.

·. Do not exceed 30A, The Short Circuit (Isc) of the solar array should be less than 30A

Battery Safety

·Use only sealed lead-acid, flooded, or gel batteries which must be deep cycle.

·Explosive battery gases may be present while charging. Be certain there is enough ventilation to release the gases.

·Be careful when working with large lead acid batteries. Wear eye protection and have fresh water available in case there is contact with the battery acid..

·Do NOT let the positive (+) and negative (-) terminals of the battery touch each other.

·Recycle battery when it is replaced.

·Over-charging and excessive gas precipitation may damage the battery plates and activate material shedding on them. Too high of an equalizing charge or too long of one may cause damage. Please carefully review the specific requirements of the battery used in the system.

image.png 

 image.png

 


Package List:
1 x  Solar Charging Controller    1 x User Manual

 

 Your Satisfaction is our Highest Priority", contact us firstly if you have any question.


Hot Tags: Solar Charging Controller, China, manufacturers, suppliers, factory
Related Products
Inquiry